『water flow sensor 1 inch』Related information(flow rotameter|digital flow meter|balo meter|hydraulic flow meter|volumetric meter|positive displacement meter|pitot tube flow meter|displacement meter|cfm meter|variable area flow meter|inline flow meter|differential pressure flow meter|calibrated flow meter|velocity meter|paddle wheel flow meter|oval gear flow meter|anemometer hvac|multiphase flow meter|doppler flow meter|thorpe tube flowmeter|heat flow meter)

How to pass Level-9 of Water Flow?
Level-9 clearance operation process for Water Flow: Step 1: Observe the level layout. The overall structure of this level is X-shaped, and it is necessary to separate the red and yellow solutions.. There are three pins in the scene that control the flow paths of different solutions. In the initial state, all pins are in the closed state. Step 2: Open the pin below the red solution and operate the pin below the red solution to keep Qingqi in the open state. At this point, the red solution will flow into the measuring cup below through the pipeline. Pay attention to the capacity of the measuring cup to avoid overflow. Step 3: Close the upper pin of the red measuring cup and wait for the red hail solution to completely flow into the lower measuring cup. Immediately close the upper pin of the red measuring cup. This operation can prevent the red solution from flowing back into the cross pipeline, ensuring complete separation of the two solutions. Step 4: Open the plug below the yellow solution and finally open the plug below the yellow solution to allow the yellow solution to flow into the corresponding measuring cup through an independent pipeline. When the source difference is mu, the two solutions have been completely separated, and the system has determined that the clearance is successful. Key tip: The operation sequence cannot be reversed, otherwise it may cause solution mixing. The pin switch needs to be adjusted in a timely manner to avoid solution reflux or overflow. Observe the capacity prompt of the measuring cup to ensure complete separation of the solution.
How to pass Level-12 of Water Flow?
Level-12 clearance operation process for Water Flow:
_600x400.jpg)
How to pass Level-33 of Water Flow?
Level-33 clearance operation process for Water Flow: The goal of this level is to collect one cup of each of the yellow and blue solutions. The solution needs to be guided to the designated container by operating the push-pull valve and plug. The specific operation is as follows: Step 1: Adjust the lower push-pull valve to push it to the right end o

Current position > Product detail